Cricut Candle wrap mesh

So here's another use for all those meshes we like to make in DS, candle wraps! I purchase this candle holder and decided a plain old candle wouldn't do, so I made a wrap with DS and Storybook. A standard pillar candle will need a 9 inch mesh (width can vary depending on the look you would like, I chose 2 1/2 inches). If you make the mesh just slightly over 9 inches (or your candle circumference) you can overlap the edges in the back, or if you can simply add a ribbon around the outside to hold it tight. Be sure to remove the paper wrap if you are going to burn the candle, or hollow the top and put in a battery flame/tealight. Cut file was very simple, I used a storybook element because the ribbon threaded nicely through it. I did it in the new format so it is all one unit and easy to resize for other candles. It is attached below if you would like it.

fallcandle.cut